Signal Interface Of The Charge Board - Mcube CubeScan BioCon-500 Service Manual

Service Manual for BioCon-500

1.3.4 Signal Interface of the Charge Board

J1 is a power input from DC adapter. And it is defined as below.
TO:
Pin No.
1
2
3
J2 is a connector for LEDs to display the status both of the DC adapter connection and
of charging. And each signal is defined as below.
TO:
Pin No.
1 ADAPTER_ON_ANODE
2 ADAPTER_ON_CATHODE
3 FAST_CHARGE_ANODE
4 FAST_CHARGE_CATHODE
J6 is a connector connected to (+) and (-) terminals of the battery board. And each
signal is defined as below.
TO:
Pin No.
1
2
3
*. J7, J4, J5: Refer to JP101, JP1, and JP2 of Analog Board, respectively.
Mcube Technology Co., Ltd.
www.mcubetech.co.kr
TM
Name
ADAPTER+ Power
ADAPTER- Power
-
Name
Name
BATTERY+ Power
BATTERY- Power
-
J1
DC Adapter
I/O Description
+16V input
Ground
- Not Connected
J2
Key Board
I/O Description
Out Adapter on LED anode
Out Adapter on LED cathode
Out Fast charge anode
Out Fast charge cathode
J6
Battery Board
I/O Description
Battery module plus
Battery module minus
- Reserved
14