Signal Interface Of The Analog Board - Mcube CubeScan BioCon-500 Service Manual

Service Manual for BioCon-500

1.3.2 Signal interface of the Analog Board

JP1 is a (+) terminal of the battery module connected from the battery module to the
analog board through the Charge Board. And its signal is defined as below.
TO:
Pin No.
1
2
JP2 is a (-) terminal of the battery module connected from the battery module to the
analog board through the Charge Board. And the signal is defined as below.
TO:
Pin No.
1
2
JP101 is a signal to control ON/OFF of DC power supplied from the DC adapter to
the Charge Board. And its signal is defined as below.
TO:
Pin No.
1
2
Mcube Technology Co., Ltd.
www.mcubetech.co.kr
TM
Name
BAT_POS
BAT_POS
Name
BAT_NEG
BAT_NEG
Name
ANP_PWR_ON
EE+5V
JP1
Charge Board
I/O
Power Input power from charge board
Power Input power from charge board
JP2
Charge Board
I/O
Ground for input power from the Charge
Power
Board
Ground for input power from the Charge
Power
Board
JP101
Charge Board
I/O
Out Analog board power on/off
Power "+5V"
Description
Description
Description
11