Mcube CubeScan BioCon-500 Service Manual page 56

Service Manual for BioCon-500
<<MAINTENANCE MODE>>
Maintenance mode should be
accessed by only qualified person.
1. To go to maintenance menu
4
press ENTER key.
2. To return top menu
press DOWN key.
▶ Cal. Value
Store Mode
System Reset
Probe Offset
5
Print Density
Outline Mode
Calibration
Exit
Mcube Technology Co., Ltd.
www.mcubetech.co.kr
TM
The initial screen of the system is
displayed
seconds
checkers. At this time, push RIGHT key
with LEFT key being pushed together
to display the screen as left.
Push
maintenance menu.
Push DOWN key to return to the
previous page.
Push ENTER key from the screen 4
above to display maintenance menu as
left.
*) Key manipulation
Use up/down key to move menu items
10
from the menu.
Maximum
Return
▶ appears beside the current menu
9
item. To replace the item value, push
7
ENTER key while the ▶ is still
On
displayed for the corresponding item.
Return
To change the item value, scroll until
the desired value appears by using
left/right value and push ENTER key.
*) Refer to the table below for the
details.
after approximately
of the appearance
ENTER key to go
10
of
to
51