Table of Contents
Advertisement
Tractor Preparation
The Brillion/Landoll Pulverizer is designed to be pulled by
a tractor equipped with or without a hammer strap. See
Figure 1-2.
Before attaching the implement, prepare the tractor as
follows:
1. Inflate the rear tractor tires equally and add ballast
according tot he tractor operator's manual.
2. Lock the tractor drawbar in the center position.
Pulverizer Preparation
1. Prior to operating the Pulverizer, inspect it thoroughly
for good operating condition.
2. Replace worn or missing parts.
3. When the machine is new, check the bolt tightness
after a few hours of operation. Tighten any loose nuts
or bolts. Check the lift wheel lug bolts daily.
4. Check the lift wheel tire inflation. Inflate all tires
equally to avoid side draft. Follow the tire
manufacturer's recommended pressures listed on the
sidewall of the tires.
DANGER
DANGER
Do not allow any bystanders to stand between
the tractor and the implement while backing up
to the implement.
Attaching to the Tractor
1. Align the tractor drawbar with the machine. Raise or
lower the hitch as needed using the jack. Attach the
unit with proper size hitch pin. See Table 3-1..
2. Always store Jack pinned on the Sleeve on top of the
Drawbar A-Frame before setting the machine in
motion.
3. Clean all hydraulic couplings and attach to the tractor.
4. Fully extend the hydraulic lift cylinders, and retract the
wing fold cylinders. Secure transport lock with hairpin
cotters. See Figures 3-6 and 3-8.
5. Attach safety chain to tractor allowing plenty of
movement for turning both directions. The safety
chain should latch securely to prevent it coming loose.
See Figure 1-2.
6. Plug the 7-Pin Connector to tractor outlet, routing
cable by avoiding pinch points.
• Make sure the tractor has a good clean receptacle,
free of dirt and corrosion.
• Make sure the 7-pin connector is inserted ALL the
way in. With tighter fitting pins, operator may think
the connector is all the way in, but really isn't.
3-2
TABLE OF CONTENTS
• Make sure the tractor receptacle cover latches
over the keyway on the 7-pin connector to hold the
connector in place.
• If an operator plugs in the 7-pin connector, but the
lights do not seem to work right, check the above
items to make sure there is a good connection with
the 7-pin connector.
DRAWBAR
CAT
2
3
Min Pin Size
1-1/4" (30mm)
154 (115 Kw)
1-1/2" (38mm)
248 (185 Kw)
Table 3-1: Hitch Pin Size
Max PTO HP
F-661-0321
Advertisement
Table of Contents
