Table of Contents
Advertisement
Lubrication Maintenance
CAUTION
Over lubrication of these bearings can cause
premature bearing failure.
Greaseable components are the same on each side.
Lubricate with quality grease or if machine is not used for
an extended period. See Figure 4-3 and 4-4.
5 x 42 or 5-1/2 x 42
Hydraulic Cylinder
Grease
Every 20 Hours
F-661-0321
TABLE OF CONTENTS
•
Every 20 hours lubricate Trunnion Bearings, Cylinder
Base Ends, Spherical Bearings and Hinge Pins.
•
Every 50 hours lubricate Wheel Hubs and
Turnbuckle.
•
Repack Wheel Hub bearings annually before each
season usage.
When the machine is not used for some time, exposed
portions of the hydraulic cylinder rods must be cleaned
and covered with a thick coat of grease to prevent
corrosion, which will damage the seal.
Grease Every 50 Hours
5 x 42 or 5-1/2 x 42
Hydraulic Cylinder
Figure 4-3: Lubrication (1 of 2)
4-5
Advertisement
Table of Contents
