Landoll Brillion WFPD38-52 Operator's Manual page 75

Clamp End Spacers - Optional
The Clamp End Spacer Kits are used to eliminate space
between the Axle Clamp and the Wheel Stop.
IMPORTANT
Unfold and lower machine prior to performing any steps.
3/8-16 x 1-3/4
Wheel Stop
Axle Spacer
Bolt,
3/8-16 x 1-3/4
Locknut,
3/8-16
F-661-0321
TABLE OF CONTENTS
Axle Spacer
Bolt,
Axle Spacer
Figure 4-9: Clamp End Spacer Kit - Optional (1 of 2)
Kit Part Number 201442 - 3/4" Axle Spacer
Kit Part Number 201443 - 1/2" Axle Spacer
Installation is the same for either kit.
1. Place the two Axle Spacers between the Axle Clamp
and the Wheel Stop.
2. Insert two 3/8-16 x 1-3/4 Bolts through the Axle
Spacers and secure with 3/8-16 Locknuts.
Refer to the Torque Table for proper bolt torque values.
Note the different torque requirement for Bolts with
Locknuts. See Page 4-1.
Locknut,
3/8-16
Axle Spacer
Axle
201442-201443 ClampEndSpacerK
Clamp
4-11