Landoll Brillion WFPD38-52 Operator's Manual page 45

V-Wheel Center Scrapers -
Optional
1. With the Rollers on level ground, attach Scraper
Brackets to The Front Frame Tube with 5/8-11
U-Bolts and Flange Locknuts. Tighten Flange
Locknuts only enough so Brackets can be adjusted
accordingly on the Frame Tube.
F-661-0321
TABLE OF CONTENTS
2. Center Scraper Bars are pre-assembled with
3. Tighten all Scraper Bracket Hardware.
Figure 2-26: V-Wheel Center Scrapers
Scrapers attached (spaced approximately 6 inches
apart). Loosen Three Scraper U-Bolts on each
Scraper Bar where the Scraper Bar will attach to the
Scraper Brackets. See Figure 2-26. Place Scraper
Bar against the Scraper Brackets Tab. Secure by
sliding the loosened 1/2-13 U-Bolts over each
Scraper Bracket Tab and tightening the Flange
Locknuts.
2-31