Table of Contents
Advertisement
V-Wheel Wing Scrapers - Optional
1. With the Rollers on level ground, attach 209842 Wing
Scraper Brackets to the Wing Frame Tube with 5/8-11
U-Bolts and Flange Locknuts. Tighten Flange
Locknut only enough so Brackets can be adjusted
accordingly on the Wing Frame Tube.
2. Attach 209843 Wing Scraper Brackets to appropriate
Wing Frame Scraper Mounting Plates with 1/2-13 x 2
Bolts and Flange Locknuts. See Figures 2-27
and 2-28.
2-32
TABLE OF CONTENTS
Figure 2-27: V-Wheel Wing Scrapers WFP 50 - Optional
3. Wing Scraper Bars are pre-assembled with Scrapers
attached (spaced approximately 6 inches apart).
Loosen Four Scraper U-Bolts on each Wing Scraper
Bar where the Scraper Bar will attach to the Wing
Scraper Brackets. See Figures 2-27 and 2-28. Place
Wing Scraper Bar against the Scraper Brackets Tab.
Secure by sliding the loosened 1/2-13 U-Bolts over
each Scraper Bracket Tab and tightening the Flange
Locknuts.
4. Tighten all Scraper Bracket Hardware.
F-661-0321
Advertisement
Table of Contents
