Transporting on a Trailer
1. Remove the short (9" long) Transport Lock from
under the Wing Support and place it over the exposed
Transport Axle Cylinder Rod.
2. Insert Clevis Pin and Hair Pin Cotter.
3. Close the Fold Shut-off Valve completely, by backing
off Jam Nut and turn Valve CW until it bottoms.
Tighten Jam Nut.
4. Raise the Transport Axle to where the Center Roller
Axle and the Transport Axle Tires are both touching
the Trailer Deck. See Figure 3-9.
Clevis Pin
Hair Pin
Cotter
9" Transport Lock Storage
Jam Nut
3-8
TABLE OF CONTENTS
5. Disconnect Drawbar from tractor.
6. Retract Telescoping Drawbar.
7. Disconnect (Quick Coupling) Hydraulic Hoses and
8. Remove Turnbuckle and the Drawbar Pins.
Exposed Hydraulic
Cylinder Rod
9" Transport Lock Storage
Fold Shut-off
Cartridge
Figure 3-8: Trailer Transport Set-Up
the Ag Harness from where the frame connects to the
Drawbar.
Flow Control
F-661-0321