Table of Contents
Advertisement
Transport
1. Check and follow all federal, state, and local
requirements before transporting the Pulverizer.
2. The Pulverizer should be transported only by tractor
required for field operation. The implement weight
should not exceed more than 1.5 times the tractor
weight. Maximum transport speed for the Pulverizer is
20 mph for the implement.
CAUTION
Excessive speed may result in loss of control of
the tractor and implement, reduced braking
ability, or failure of the implement tire or
structure. Do not exceed the implement
maximum specified ground speed regardless of
the capability of the maximum tractor speed.
3. When towing equipment in combination, the
maximum equipment ground speed shall be limited to
the lowest specified ground speed of any of the towed
implements.
Maximum transport speed shall be the lesser of
travel speed specified in the operator's manual,
speed identification symbol, information sign of
towed equipment, or limit of road conditions.
• EXAMPLE: If the tractor is capable of 25 mph, the
first implement has a SIS for 19 mph, and the last
implement's operator's manual states its specified
ground speed is 15 mph, the towed equipment
combination ground speed limitation is 15 mph.
4. Slow down when driving on rough roads. Reduce
speed when turning, or on curves and slopes to avoid
tipping. Equipment altered other than the place of
manufacture may reduce the maximum transport
speed. Additional weight, added tanks, harrowing
attachments, etc. may reduce implement load
carrying capabilities.
5. A safety chain is provided with the implement to
insure safe transport. See Figure 1-2.
• The safety chain should have a tensile strength
equal to or greater than the gross weight of the
implement. The chain is attached to the lower hitch
clevis hole with two flat washers between the
clamp plates to assure a tight connection. Always
use a 1" diameter Grade 8 bolt for this connection.
• Attach the safety chain to the tractor drawbar.
Provide only enough slack in the chain for turning.
Do not use an intermediate chain support as the
attaching point for the chain on the tractor. Do not
pull the implement by the safety chain.
3-14
TABLE OF CONTENTS
• Regularly inspect the safety chain for worn,
stretched, or broken links and ends. Replace the
safety chain if it is damaged or deformed in any
way.
6. Check that tires are of proper size, load rating, and
inflated to manufacture specifications before
transporting. Check wheel lug bolts to ensure
tightness.
7. Know the transport heights and widths of the unit
before transporting. Use caution when transporting
near bridges and power lines.
Electrocution can occur without direct contact.
8. Raise the machine to full transport height.
9. Install transport lock. Do not depend solely on
implement hydraulics for transport. See Figures 3-6
and 3-8.
Failure to use transport lock during transport
may result in permanent equipment damage,
serious injury or death.
10. Transport during daylight hours when ever possible.
Always use flashing warning lights, except where
such use is prohibited by law. Make sure lights,
reflectors and SMV emblem are clearly visible and
operating. remove any obstructions such as dirt, mud,
stalks or residue that restricts view before
transporting.
a
WARNING
WARNING
Figure 3-11: SMV Sign
F-661-0321
Advertisement
Table of Contents
