Linhai T-Boss 550 Service Manual page 93

CHAPTER 3 ENGINE
Install guide pin and spacer ①
Note: To avoid damage to the oil seal lip during
assembly, slide the lip with a 0.1mm steel sheet
as guide.
Install spring seat. Align hole A with hole B.
Install spring and spring plate. Insert spring end into
the hole.
Compress spring with special tool.
Align the secondary sheave end with spring plate
hole.
Tool: Secondary sheave spring compressor
Tighten ring nut temporarily.
Remove the special tool from secondary sheave.
T-Boss550 SERVICE MANUAL20.0
CHAPTER 3 ENGINE PAGE. 3- 68