Primary Sliding Sheave And Fixed Sheave Check - Linhai T-Boss 550 Service Manual

CHAPTER 3 ENGINE
Primary Sliding Sheave and Fixed Sheave
Check the drive face for any abnormal conditions
such as damage or stepped wearing.
Damage or wearing: → Replace
Install oil seal with special tool.
Tool: Bearing install set
Assembly
Reverse the removal procedure of primary sliding and
fixed sheave for installation.
Pay attention to the following:
Apply grease to inner bore and oil seal lip.
Note:
Wipe off any excessive grease thoroughly.
Take care not to attach any lubricant grease
to contact surface of drive belt.
Material: Lubricant grease
Position 8 rollers ①on the primary sliding sheave
Install 4 dampers ② to cam ③
Install cam to primary sliding sheave.
Notes:
When inserting the spacer, press down the cam
so that the rollers will not come out of position.
T-Boss550 SERVICE MANUAL20.0
CHAPTER 3 ENGINE PAGE. 3- 64