Wheel Removal; Wheel Installation - Linhai T-Boss 550 Service Manual

CHAPTER 2 MAINTENANCE
Always adjust both shock absorber spring preload to
the same setting. Uneven adjustment can cause
poor handling and loss of stability.
Turn the adjuster ○
1
spring preload.
Standard position: 3
Minimum (Soft) position: 1
Maximum (Hard) position: 5
2.8 WHEELS
Inspect all wheels for runout of damage.
Check wheel nuts and ensure they are tight.
Do not over tighten the wheel nuts.

WHEEL REMOVAL

1. Stop the engine, place the transmission in gear and
lock the parking brake.
2. Loosen the wheel nuts slightly.
3. Elevate the side of the vehicle by placing a suitable
stand under the footrest frame.
4. Remove the wheel nuts and remove the wheel.

WHEEL INSTALLATION

1. With the transmission in gear and the parking Brake
locked, place the wheel in the correct Position on the
wheel hub. Be sure the valve stem is toward the
outside and rotation arrows on the tire point toward
rotation.
2. Attach the wheel nuts and finger tighten them.
Install as shown at left for front or rear wheels.
3. Lower the vehicle to the ground.
4. Securely tighten the wheel nuts to the proper
Torque listed in the table. On wheel nuts, Make
sure tapered end of nut goes into taper on wheel.
Wheel Nut Torque Specifications
Bolt Size
Front M10X1.25
Rear M10X1.25
CAUTION: If wheels are improperly installed it could
affect Vehicle handling and tire wear.
to increase or decrease the
Specification
55Lbs.Ft
55Lbs.Ft
T-Boss550 SERVICE MANUAL 20.0
75Nm
75Nm
CHAPTER 2 MAINTENANCE PAGE. 2- 12