Linhai T-Boss 550 Service Manual page 192

CHAPTER 5 FINAL DRIVE
Important: Before staring any operation
On the gearbox， make sure that never clean
the gearbox with a high pressure water jet.
The pinion gear assembly (A) is NOT
intended to be disassembled from the case,
as it requires special tooling in order to
properly reassemble. If there is any damage
to the pinion gear, bearings or case, the
assembly must be replaced. Pinion and ring
gear shimming information is NOT provided
due to manufacturing requirement.
1.remove the breathing airbag(NO.48).
→Fig 0
2.Remove the oil drain plug (NO.23) and let the
oil drain from the gearbox.
Important: Clean the plug carefully.
Replace the sealing washer (NO.24) before it's
assembled. →Fig 1
Fig 0
T-Boss550 SERVICE MANUAL 20.0
3.Remove the differential solenoid (NO.14)
from the gearcase cover if servicing the
solenoid, shift lever, shift lever spring, or shift
yoke. If none of these items are being
serviced. The solenoid can remain installed in
the gearcase cover. →Fig 1
4.Remove the Bolts M8×50 (NO.4), Remove
assembly (A). →Fig 3
CHAPTER 5
Fig 1
Fig 2
FINAL DRIVE. 5- 16