Chapter5 - Linhai T-Boss 550 Service Manual

CHAPTER 5 FINAL DRIVE
3. Slide the rear drive axle into the knuckle.
4. Lift knuckle into place and install bolt to upper
and lower control arm. Torque bolt to 45 ft.lbs (60
Nm).
5. Install the washer and the new spindle nut.
6. Lower the vehicle. Torque the spindle retaining
nut to 103 ft.lbs. (140 Nm).
7. Knock on the edge of the spindle nut, so that it
can be clamped into the limit slot.
8. Install brake caliper using new bolts. (Apply
Loctite™ 243 to threads) Tighten bolts to 18 ft.lbs
(24 Nm)
9. Install the wheel and wheel nuts. Torque wheel
nuts to 55ft.lbs. (75 Nm).
T-Boss550 SERVICE MANUAL 20.0
CHAPTER 5 FINAL DRIVE. 5- 13