Linhai T-Boss 550 Service Manual page 100

CHAPTER 3 ENGINE
Oil strainer
Check oil strainer ① and O-ring ② for damage
Damaged oil strainer: → Replace
Clean the surface of oil strainer with engine oil
Relief Valve
Check the valve body ① 、valve ② and spring ③O
ring④ for damage or wear.
Damage or wear: → Replace
Drive Bevel Gear
Use a clean rag to protect the drive bevel gear shaft,
clamp it to the pliers.
Loosen drive bevel gear nut 3, remove the drive
bevel gear 4 and adjust washer 5
Check the drive bevel gear 4 and output driven gear
2 for rust, scratch, wear or damage. Replace if any.
Check if the bearing 8 turns smoothly, replace with a
new bearing if necessary.
Adjust Washer 5 if any of right crankcase, drive
bevel gear 4, or drive bevel gear cover 1 is replaced.
Refer to bevel gear adjustment for details.
Apply engine oil to bearing 8 when assembling and
tighten nut 3 to the specified torque.
Drive bevel gear nut
Tightening torque: 145N•m
T-Boss550 SERVICE MANUAL20.0
1. Drive bevel gear cover 5. Adjust washer
2. Output driven gear
3. Drive bevel gear nut 7. Bearing press
4. Drive bevel gear
CHAPTER 3 ENGINE
6. Drive bevel
gear shaft
8. Bearing
PAGE. 3- 75