Linhai T-Boss 550 Service Manual page 171

CHAPTER 4 CHASSIS
3. Remove the brake caliper. Suspend the brake
caliper from the frame with a wire.
NOTE: Do not let the brake caliper hand from
the brake line or damage may occur.
4. Remove the spindle nut, and washer. Remove
the hub assy by sliding it off of the shaft.
5. Loosen two bolts that secure the rear knuckle to
the A-arm. Remove the rear knuckle assembly
by sliding it off of the shaft.
6. Remove the bolt that secures the shock and coil
to the lower A-arm.
7. Loosen two bolts that secure the A-arm to frame
by alternating each about 1/3 of the way until
A-arm can be removed. Perform this procedure
on the upper A-arm.
T-Boss550 SERVICE MANUAL20.0
CHAPTER 4 CHASSIS PAGE. 4- 5