Linhai T-Boss 550 Service Manual page 90

CHAPTER 3 ENGINE
Install spacer
Secondary Sheave
Disassembly
Use special tool and holder to hold the secondary
sheave. Remove secondary sheave nut with special
tool.
Caution:
Do not remove the ring nut before attaching the
clutch spring compressor.
Tool: Nut Wrench
Sheave Holder
Attach special tool to the secondary sliding sheave
and compress it by turning in the tool handle.
Note:
Make sure that spring end A is inserted into slot
B of the tool handle.
Remove ring nut.
Tool: Secondary sliding sheave spring compressor
Note:
Since a high spring force applies to the
secondary sliding sheave, take special care that
the secondary sliding sheave will not come off
abruptly.
Slowly loosen tool handle and remove the special
tool.
T-Boss550 SERVICE MANUAL20.0
CHAPTER 3 ENGINE PAGE. 3- 65