Linhai T-Boss 550 Service Manual page 53

CHAPTER 3 ENGINE
Inspection:
Inspect drive belt for wear and damage. If any cracks or
damages are found, replace drive belt with a new one.
Inspect drive belt for width, if width is out of service limit,
replace drive belt with a new one.
Service Limit: 33.5mm
Tool: Vernier Caliper
Installation
Reverse the removal procedure for installation. Pay
attention to the following:
Insert drive belt, as low as possible, between secondary
sliding sheave and primary fixed sheave.
Hold secondary sheave and tighten the nut
to the specified torque.
Nut, Secondary Sheave: 115 N•m
Install primary sheave and nut. Hold the primary sheave
and tighten the nut to the specified torque.
Nut, Primary Sheave:115N•m
Turn primary sheave, until the drive belt is properly
seated and both the primary and secondary sheaves
rotate together smoothly and without slipping.
Caution:
Fit the drive belt with the arrow on the drive belt
points toward normal turning direction.
The drive belt contact surface of the driven face
should be thoroughly cleaned.
Install CVT cover
T-Boss550 SERVICE MANUAL20.0
CHAPTER 3 ENGINE PAGE. 3- 28