To Alignment; Braking System Inspection - Linhai T-Boss 550 Service Manual

CHAPTER 2 MAINTENANCE
T-Boss550 SERVICE MANUAL 20.0
upwards.
2.5 TOE ALIGNMENT
METHOD: STRAIGHTEDGE OR STRING
Be sure the steering wheel in a straight ahead position.
NOTE: String should just touch side surface of rear tire on
each side of the UTV.
Measure from string to rim at front and rear of rim.
Rear rim measurement (A) should be 1/8" to 1/4" (3 to 6
mm) more than front rim measurement (B).
Always pay attention to tie rods assembly, Both ends
must screw in same and enough threads length.

2.6 BRAKING SYSTEM INSPECTION

The following checks are recommended to keep the
braking system in good operating condition. Service life of
braking system components depends on operating
conditions. Inspect brakes in accordance with the
maintenance schedule and before each ride
Keep fluid level in the master cylinder reservoir to the
indicated level on reservoir.
Use DOT 3 brake fluid.
NOTE: Use new brake fluid or brake fluid from a sealed
container to avoid contamination to system.
Check brake system for fluid leaks.
Check brake for excessive travel or spongy feel.
Check friction pads for wear, damage and looseness.
Check surface condition of the disc.
CHAPTER 2 MAINTENANCE PAGE. 2- 9