Linhai T-Boss 550 Service Manual page 112

CHAPTER 3 ENGINE
Apply sealant ①to the mating face of right
crankcase.
Note: Apply sealant evenly in an uninterrupted thin line.
Install 5 dowel pins②
Assemble crankcase and tap slightly with a rubber
hammer so that the crankcase is properly fitted.
Install bolt and tighten to the specified torque.
Crankcase bolt tightening torque: M6: 10N•m
Note: Crankcase bolts should be tightened diagonally in
several steps.
Place the steel ball and install gear positioning bolt
and tighten the bolt to the specified torque.
Gear positioning bolt tightening torque: 40N•m
Engine Right
Timing Chain
Put on timing chain (2)
Clutch
Install clutch (1) and nut (2). Tighten the nut to the
specified torque (left thread).
Clutch nut tightening torque: 80N•m
M8: 25N•m
T-Boss550 SERVICE MANUAL20.0
CHAPTER 3 ENGINE PAGE. 3- 87