Pulscon LTC
Function group "output" (06), - "profibus param." (06), PROFIBUS PA only
8.16
–
+
E
Selects the value displayed in "measured value" (000).
Selection:
•
measured value
•
display value
measured value
The configured measured value is displayed in the "measured value" (000) function.
display value
The value in "display value" (069) is displayed in the "measured value" (000)
function.
Caution!
"
This function is available for PROFIBUS PA devices only!
8.17
–
+
E
In this function, enter the level (or volume, weight) at which the output current should be
20 mA. This entry is only required if you have selected the "current turn down" option
in the "curr. output mode" (063) function.
Caution!
"
This function is available for HART devices only!
8.18
–
+
E
This field can be set externally, e. g. from a PLC. The value is then displayed as the
main measured variable in the display by selecting the
"select v0h0" (068) = "display value" function.
Caution!
"
This function is available for PROFIBUS PA devices only!
Function "select v0h0" (068), PROFIBUS PA only
Function "20mA value" (069), HART only
Function "display value" (069), PROFIBUS PA only
51