Function Group "Output" (06), - "Profibus Param." (06), Profibus Pa Only; Function "Commun. Address" (060), Hart Only; Function "Instrument Addr." (060), Profibus Pa Only; Function "No. Of Preambels" (061), Hart Only - Pepperl+Fuchs Pulscon LTC Description Of Instrument Functions

Pulscon LTC

Function group "output" (06), - "profibus param." (06), PROFIBUS PA only

8

– +
E

– +
E
8.1

– +
E
Enter the communication address for the instrument with this function.
• Standard: 0
• Multidrop: 1 ... 15
In multidrop mode, the standard output current is 4 mA. This can be changed in the
"fixed cur. value" (064) function.
Caution!
"
This function is available for HART devices only!
8.2

–
+
E
The PA bus address is displayed in this field. The address is set either directly on the
instrument using DIP switches (see instrument operating instructions) or using a special
Set Slave Address command via the bus, e. g. by the PACTware
Caution!
"
This function is available for PROFIBUS PA devices only!
8.3

– +
E
Enter the number of preambles for the HART protocol with this function. An increase in
the value is advisable for "bad" lines with communications problems.
Caution!
"
This user input is available for HART devices only!
Function group "output" (06),
- "profibus param." (06), PROFIBUS PA only

Function "commun. address" (060), HART only

Function "instrument addr." (060),
PROFIBUS PA only

Function "no. of preambels" (061), HART only

Display at HART instrument
Display at PROFIBUS PA instrument
TM
.
45