Electrical Requirements Of The Machine; Exhaust System Requirements - Trotec Speedy 400 Operating Manual

3.2

Electrical requirements of the machine

Laser power
Voltage
Fuse
Power consumption AC and
WC
* T = time lag (slow triggering)
Caution
Inadequate or inappropriate power sources can lead to machine damage and are not covered by any
liability.
Verify that the electrical outlet is capable of providing the proper voltage, frequency and amperage
required by the laser machine described in this manual.
Caution
Electrical noise, unstable power supply as well as voltage spikes in power supply can cause interference
and possible damage to the electronics of the laser machine.
Notice
Use an individual circuit for the laser machine and the PC and an individual circuit for the exhaust system.
Install your computer to the same circuit as the laser machine to prevent electromagnetic interactions.
Furthermore it is highly recommended that you use a overvoltage protection switch to protect your
computer equipment.
If electrical power fluctuations, brownouts or power outages are a problem in your area, an electrical line
stabilizer, UPS (Uninterruptible Power Supply) or backup generator are required. When installing any of
these devices, ensure that they meet the electrical requirements of the laser machine.
3.3

Exhaust system requirements

Danger
Danger of emission of toxic gases, vapors or dust.
During laser operation, toxic aerosols may be produced.
– The laser system may be operated only with properly installed and operating exhaust system.
–
Check with the material manufacturer for its toxic effect.
55–80 W (TL4 CO )
2
20-50 W (fiber)
230 V~ 115 V~
8A (T)* 16A (T)*
1590 W 1590 W
85–100 W (TL6 CO )
2
20-50 W (fiber)
230 V~
12A (T)*
2100 W
Technical Data
105–120 W (TL8 CO )
2
20-50 W (fiber)
230 V~
12A (T)*
2100 W
27