Acrylic Top Lid; Side Cover; In Case Of Safety Device Malfunction; Secondary (Indirect) Hazards - Trotec Speedy 400 Operating Manual

2.7.6

Acrylic top lid

The type of acrylic top lid depends on the laser type. It protects the operator from uncontrolled emission of laser
radiation.
2.7.7

Side cover

The side panels protect from laser light and must always be closed and properly attached.
2.7.8

In case of safety device malfunction

Actual or presumed damage to the safety devices can cause injury or damage. Following measures must be carried out.
1. Press the emergency stop button.
2. Disconnect the machine from the mains.
3. Contact our Technical Support in your local area.
2.8

Secondary (indirect) hazards

2.8.1

Fire hazard

Warning
Fire hazard
Fire hazard from gas and processing of inflammable materials.
– Do not operate the device without supervision.
– Keep CO
If a main laser beam hits easily flammable material, e.g. paper, this may ignite and a fire can quickly occur. Therefore,
before switching on the laser, you should make absolutely sure that there is no easily flammable material in the beam
path.
Furthermore, gases that can form below the material to be processed may ignite. Especially if the extraction
requirements are not met.
Inadequate care and cleaning of the system increases the risk of flame formation.
Regularly check your air cooling system on the laser. The function of the filters and fans in particular should be checked
regularly so that defects caused by excess temperature are avoided.
fire extinguisher ready at hand in the immediate vicinity of the device.
2
Safety
21