Notice
Using a flexx lens the focus point differs depending on the laser source.
Note when focusing using a focus tool, the standard focus tool supplied with a flexx lens is always adjusted for a fiber
laser source. Therefore it must only be used in conjunction with a fiber laser source.
7.8.2
Sonar Technologie
Caution
If the ultrasonic sensor is heavily soiled, the laser head may be damaged if it therefore hits the material or
the worktable.
Notice
This focusing mode is especially well-suited for all sound-relective materials.
TM
1. Make sure that the ultrasonic sensor is cleaned.
2. Select the correct lens in the control soware settings.
3. Simultaneously press the two keys of the working table control
button Z (1) so that the laser beam is automatically focused on the
workpiece.
4. Focusing completed and laser processing can begin.
Operation
61