Relocation Of The Machine - Trotec Speedy 400 Operating Manual

Caution
The lens unit should be unpacked only aer installation of the machine. The lenses are high-quality
optical components which must be kept clean in order to ensure optimum marking results. Never touch
the lenses with bare fingers.
STEPS:
1. Position the transport case vertically on level ground (using a pallet truck or forkli).
2. Remove any vertical tightening straps.
3. First remove the top and aerwards the side plates of the transport case.
4. Slide out the two wooden rails in the form of ramps that are stored beneath the machine.
5. To secure the machine against moving, the wheels are locked using wooden blocks.
In order to remove those blocks, put the two wooden rails together, push the upper part of the rails under one side
of the machine and press down the rail in order to reach a levering effect.
6. Pull out the blocks.
7. Repeat this procedure on the opposite side as well.
8. Now you can pull out the blocks.
5.8

Relocation of the machine

STEPS:
1. Switch off the machine.
2. Disconnect the power cable.
3. Remove the exhaust system.
4. Reposition the machine (e.g. with auxiliary equipment if necessary) and place it on a level, clean floor.
5. Adjust the machine.
6. Initial commissioning of the electrical system.
7. Carry out function test.
Caution
Transport the machine only in its original packaging. Ensure the wooden crates are properly secured
otherwise the crates can slip, tip or fall over during transport.
Observe the corresponding safety norms and regulations from the chapters "Safety notes" and
"Transport".
– When transporting over long distances, use transport boxes including transport securing.
Transport
43