Focus Tool - Trotec Speedy 400 Operating Manual

Operation
Caution
If workpieces with more than 66.14 lbs (30 kg) have been placed on the table, the table must not be
moved up or down anymore as this might damage the mechanics of the machine.
It is mandatory to focus on the height of the material before loading material of 66.14 lbs (30 kg) and
above.
Notice
Defects from head crashes (working head hits material or working table) are excluded from warranty.
7.8.1

Focus tool

60
1. Move the processing head over the material to be engraved
by means of the Laser head control button X/Y (2) on the
keypad.
2. Hang the focus tool (3) on the allocated space on the laser
head so that the focus tool can move unhindered.
3. Move the X-axis downwards by pressing the Working table
control button Z (1).
4. Before the focus tool reaches the work piece, move the
working table upwards very slowly and step by step by briefly
tapping the Working table control button Z (1) until the focus
tool tilts to the side or falls off its position.
Now the lens is focused onto the surface of the material.