Electrical Requirements - Trotec Speedy 360 flexx Operation Manual

Speedy 360
4.3

Electrical requirements

Laser Power 35–50 W (CO
10-50 W (fiber)
AC
Voltage 230VAC
Fuse 8AT
Power consumption 1200 W
* AC = air condition
Inadequate or inappropriate power sources can lead to machine damage and are not
covered by any liability.
Verify that the electrical outlet is capable of providing the proper voltage, frequency and
amperage required by the laser machine described in this manual.
Electrical noise, unstable power supply as well as voltage spikes in power supply can
cause interference and possible damage to the electronics of the laser machine.
Use an individual circuit for the laser machine and the PC and an individual circuit for the
exhaust system. Install your computer on the same circuit as the laser machine to
prevent electromagnetic interactions.
Furthermore it is highly recommended that you use a surge suppression plug to protect
your computer equipment.
If electrical power fluctuations, brownouts or power outages are a problem in your area,
an electrical line stabilizer, UPS (Uninterruptible Power Supply) or backup generator are
required. When installing any of these devices, ensure that they meet the electrical
requirements of the laser machine.
BA 8032_2.2_EN (05/2016)
) 55–80 W (CO
2 2
10-50 W (fiber)
AC
115VAC 230VAC 115VAC
16AT 10AT 16AT
1200 W 1400 W 1400 W
) 85–100 W
(CO )
2
10-50 W
(fiber)
AC
230VAC
12AT
1900 W
105–120 W
(CO )
2
10-50 W
(fiber)
AC
230VAC
12AT
1900 W
www.troteclaser.com
31 / 90