Electrical - Requirements - Trotec Speedy 400 flexx Operation Manual

3.4

Electrical - Requirements

Make sure that your electrical outlet is capable of providing the proper
voltage, frequency and amperage that the laser system requires.
We recommend having individual circuits for

Lasermachine and PC

Extractor
Recommended fuse 10A (230V), 10A (115V).
Please install your computer to the same circuit as the laser marker to prevent
electromagnetic interactions.
DAMAGES FROM AN INADEQUATE OR INAPPROPRIATE POWER SOURCE
ARE NOT COVERED UNDER WARRANTY.
Noisy or unstable electricity as well as voltage spikes can cause interference and
possible damage to the electronics of the laser system. It is better to connect the
laser system to a dedicated electrical line.
It is highly recommended that you use a surge suppression plugs to protect your
computer equipment.
If electrical power fluctuations, brown outs or constant power outages are a problem
in your area, an electrical line stabilizer, UPS (Uninterruptible Power Supply) or
backup generator might be required. If installing any of these devices, make sure
that they meet the electrical requirements of the laser system.
It is your responsibility to provide a suitable electrical supply.
8026 | V5.0_EN (11/2015)
Technical changes reserved
Trotec Laser GmbH
Page 20 of 62