Change The Filter Mat; Cleaning; Machine; Optics In General - Trotec Speedy 400 Operating Manual

8.3

Change the filter mat

If it is necessary to change the filter mat, open the power supply cover on the rear of the machine and replace it.
8.4

Cleaning

8.4.1

Machine

1. Move the working table into a position in which it is easiest for you to clean the surface with a window cleaning
agent and paper towels.
2. Switch off and disconnect the machine from the mains.
3. Open the transparent acrylic top lid and front panel.
4. Thoroughly remove all loose dirt particles and deposits in the interior of the machine (e.g. with a vacuum cleaner or
broom).
5. Clean the air guide plate and vent slots of the exhaust box inside the machine using a dry or damp cloth or brush.
6. Clean the cover of the laser source and vent slots at the back of the machine using a dry or damp cloth.
7. Clean the transparent acrylic top lid using a dry or slightly damp cotton cloth. Do not use paper towels as they could
scratch the acrylic.
8.4.2

Optics in general

Trotec Laser GmbH recommends to use the cleaning set enclosed. Alternatively, use high-quality cotton swabs together
with the provided cleaning liquid.
Maintenance
71