Electrical - Requirements - Trotec Speedy 300 fiber Operation Manual

8017 Trotec Speedy 300 fiber
BEFORE OPERATION
3.4 Electrical – Requirements
Make sure that your electrical outlet is capable of providing the proper
voltage, frequency and amperage that the laser system requires.
We recommend having individual circuits for
Lasermachine and PC
Extractor
Recommended fuse: 10A (115V/230V).
Please install your computer to the same circuit as the laser to prevent
electromagnetic interactions.
DAMAGES FROM AN INADEQUATE OR INAPPROPRIATE POWER
SOURCE ARE NOT COVERED UNDER WARRANTY.
Noisy or unstable electricity as well as voltage spikes can cause interference
and possible damage to the electronics of the laser system. It is better to
connect the laser system to a dedicated electrical line.
It is highly recommended that you use a surge suppression plugs to protect
your computer equipment.
If electrical power fluctuations, brown outs or constant power outages are a
problem in your area, an electrical line stabilizer, UPS (Uninterruptible Power
Supply) or backup generator might be required. If installing any of these
devices, make sure that they meet the electrical requirements of the laser
system.
It is your responsibility to provide a suitable electrical supply.
28/07/2015 Trotec Produktions- und Vertriebs GmbH_Linzer Strasse 156, A-4600 Wels, Austria, Technical Support
tel_+43 (0)7242 239-7000, fax_+43 (0)7242 239-7380, mailto: techsupport@troteclaser.com
19 / 54