Changing The Front And Rear Direction Indicator Bulbs; Changing The Dashboard Bulbs - APRILIA SCARABEO 50 I.E - 2002 Manual

To change the bulb:
LOW/HIGH BEAM BULB
Remove the front handlebar cover, see 64
(REMOVING THE FRONT HANDLEBAR
COVER).
Rotate the bulb socket (1) counterclock-
wise and remove it.
Remove the bulb from the seat.
NOTE
Be sure to maintain the same ori-
entation as the old bulb when you install the
new bulb. Do not force the bulb, it will go
easily if it is properly oriented.
use and maintenance Scarabeo 50
76
CHANGING THE FRONT AND REAR
DIRECTION INDICATOR BULBS
Carefully read p. 75 (BULBS).
NOTE
Before changing a bulb, check the
fuse, see p. 71 (CHANGING FUSES).
Place the vehicle on the center stand.
Unscrew and remove the screw (3).
NOTE
While removing the lens, use extra
care to be sure that you do not break the
key.
Remove the lens (4).
NOTE
Upon reassembly, position the lens
correctly in its seat.
CAUTION
Tighten the screw (3) moderately and with
care to avoid damaging the lens.
Push the bulb (5) in slightly and rotate it
counterclockwise.
Extract the bulb from its seat.
NOTE
Insert the bulb in the bulb socket,
carefully aligning the two bulb pins with their
guides in the socket.
Correctly install a new bulb of the same type.
NOTE
If the bulb socket (6) has fallen out
of its seat, replace it correctly, ensuring that
the slot in the reflector aligns with the screw
hole in the body of the turn signal lamp.
CHANGING
THE DASHBOARD BULBS
Carefully read p. 75 (BULBS).
NOTE
Before changing a bulb, check the
fuses, see p. 71 (CHANGING FUSES).
The dashboard contains:
– the warning light bulbs;
– the dashboard lighting bulbs.
To change the bulbs:
Remove the front handlebar cover, see p.
64 (REMOVING THE FRONT HANDLE-
BAR COVER).