Changing The Front/Rear Direction Indicator Bulbs - APRILIA RS 250 - 1998 Manual

LOW BEAM BULB
Working on the rear left side of the front
part of the fairing, move the protection
element (1) with your hands.
Withdraw the connector (2).
Release the check spring (3) positioned
at the rear of the bulb socket (4).
Extract the bulb (5) from its seat and re-
c
place it.
Insert the bulb in the bulb soc-
ket, making the relevant positio-
ning seats coincide.
CHANGING THE FRONT/REAR
DIRECTION INDICATOR BULBS
Carefully read p. 75 (BULBS).
c
Before changing a bulb, check
the fuses, see p. 72 (CHANGING
THE FUSES).
Position the vehicle on the stand, see
p. 46 (POSITIONING THE VEHICLE ON
THE STAND).
Unscrew and remove the screw (6).
Remove the protection glass (7).
a
Upon reassembly, tighten the
screw (6) moderately and care-
fully, in order not to damage the
protection glass.
Press the bulb (8) slightly and rotate it
anticlockwise.
Extract the bulb from its seat.
c
Insert the bulb in the bulb soc-
ket, making the two bulb pins
coincide with the relevant guides on the
socket.
Correctly install a new bulb of the same
type.
c
If the bulb socket goes out of its
seat, insert it correctly, making
the bulb socket opening coincide with
the screw seat.
use and maintenance RS 250 77