Changing The Front And Rear Direction Indicator Bulbs - APRILIA RSV mile Use & Maintenance Book

PARKING LIGHT BULB (CENTRAL UP-
PER POSITION)
◆
Remove the front part of the fairing com-
pletely, see p. 117 (REMOVING THE
FRONT PART OF THE FAIRING).
Working from the central upper position of
the rear part of the fairing.
While removing a bulb socket, do not
pull on the wires.
◆
Grasp the bulb socket (12), pull it and re-
move it from its seat.
◆
Remove the parking light bulb (3) and re-
place it with an identical bulb.
NOTE
Ensure that the bulb is correctly
inserted in the bulb socket.
◆
Insert the bulb socket (12) in its seat.
◆
Replace the front part of the fairing com-
pletely, see p. 117 (REMOVING THE
FRONT PART OF THE FAIRING).
142
use and maintenance RSV mille
CHANGING THE FRONT AND REAR
DIRECTION INDICATOR BULBS
Carefully read p. 139 (BULBS).
NOTE
fuses, see p. 132 (CHANGING FUSES).
To change the bulb:
◆
Place the vehicle on the stand, see p. 83
(PLACING THE VEHICLE ON THE
STAND).
◆
Unscrew and remove the screw (13).
NOTE
tra care to be sure that you do not break
the key.
◆
Remove the lens (14).
NOTE
correctly in its seat.
! - !
RSV mille R
Before changing a bulb, check the
While removing the lens, use ex-
Upon reassembly, place the lens
Tighten the screw (13) moderately and
with care to avoid damaging the lens.
◆
Push the bulb (15) in slightly and rotate it
counterclockwise.
◆
Extract the bulb from its seat.
NOTE
Insert the bulb in the bulb socket,
carefully aligning the two bulb pins with
their guides in the socket.
◆
Correctly install a new bulb of the same
type.
NOTE
If the bulb socket (16) has fallen
out of its seat, replace it correctly, ensuring
that the slot in the reflector aligns with the
screw hole in the body of the turn signal
lamp.