Connection For Side-By-Side Installation Of Cabinet Units - Siemens SINAMICS S120 Device Manual

3.3.6

Connection for side-by-side installation of cabinet units

Description
An accessory kit is provided with each cabinet or transport unit for the connection of cabinet
units in a side-by-side installation. The table below shows the content of this accessory kit for
connecting the cabinet units.
Table 3- 3 Content of the accessory kit for connecting the cabinet units
Quantity Material
1 x Sealing strip
3 x Outer cabinet connectors
including fasteners
3 x Inner cabinet connectors
including fasteners
Assembling
1. Glue sealing strip to the cabinet cross-beams of the cabinets to be connected.
2. Push the cabinets together. The front and rear sides of all cabinets must stand next to
each other. The distance between the cabinets must be approximately 0.12 inch (3 mm).
3. Install the outer and inner cabinet connectors according to the following drawing.
4. If necessary, reattach the protective covers and doors. The earth connections must also
be attached to the doors.
Cabinet Modules NEMA
Manual, 04/2014, A5E03586450A
Image Notes
The sealing strip must be glued on before assembling
the cabinets.
The cabinet connector is fitted and screwed on from
the outside.
Tightening torque: 9 Nm
The cabinet connector is fastened with 4 screws.
Tightening torque: 5 Nm
Mechanical installation
3.3 Installation
59