Leds On The Tm150 Temperature Sensor Module - Siemens SINAMICS S120 Device Manual

LED Color
Fail-safe digital outputs with associated readback channel
F_DO y Green
(0+..3+,
0-..3-)
Readback input DI 2y for output F_DO y (y = 0 ... 3) for test stop. The status of the LEDs also depends on the type of ex-
ternal circuit.
DI 2y –
Green
Inputs x+1 (DI 1+, 3+, .. 19+) can be individually adjusted using a parameter (see SINAMICS S120/S150 List Manual)
1)
7.15

LEDs on the TM150 temperature sensor module

TM150 Temperature Sensor Module ( -A151 to -A154)
Table 7- 24 Description of the LEDs on the TM150
LED Color
READY -
Green
Orange
Red
Green /
Red
Green /
Orange
or
Red /
Orange
Cabinet Modules NEMA
Manual, 04/2014, A5E03586450A
Status
Continuous light Output y (y = 0 to 3) carry a signal
Off
Continuous light Both output lines y+ and y- carry no signal
Status
Off Electronics power supply is missing or outside the permissible tolerance range.
Continu- The component is ready for operation and cyclic DRIVE-CLiQ communication is
ous light taking place.
Continu- DRIVE-CLiQ communication is being established.
ous light
Continu- At least one fault is present in this component.
ous light Note:
LED is activated irrespective of any reconfiguring of the corresponding messages.
Flashing Firmware is being downloaded.
0.5 Hz
Flashing Firmware has been downloaded.
2 Hz Wait for POWER ON.
Flashing Detection of the component via LED is activated (p0154)
2 Hz Note:
The two options depend on the LED status when component detection is activated
via p0154 = 1.
7.15 LEDs on the TM150 temperature sensor module
One of the two output lines y+ or y- or both lines of output y carry a
signal
Description
Description, cause
Diagnostics
347