Unpacking Your Shipment In The Correct Order; Rack And Cabinet Requirements - ClearCube A1010 User Manual

• Contact ClearCube Support for a replacement. For information about contacting Support,
see

Unpacking Your Shipment in the Correct Order

ClearCube components are typically shipped in separate containers. The following list
describes the components shipped for typical installations and specifies the order in which you
should unpack your shipment.
Note:
1. Chassis—Only unpack before attaching to a previously-installed rack or cabinet.
2. PC blades—Only unpack before inserting in an appropriate A–Series chassis.
–
–
3. User ports—Only unpack before connecting to a blade. I/Ports are shipped with or
without power supplies and keyboards, depending on the I/Ports that you use in your
environment. See the documentation included with your user ports for instructions about
setting up, configuring, and using your user ports.
4. Keyboards—Only unpack before connecting to user ports. Keyboards, if not included
with user ports, might be bulk-packaged. See the documentation included with your user
ports for instructions about connecting monitors and keyboards to user ports.
Note:
See "Installing an A–Series
installing chassis. See
installing blades.

Rack and Cabinet Requirements

Before installing ClearCube components it is important to properly prepare the site where you
will install the chassis and PC blades. This chapter provides information on how to plan for
installation.
12 • Site Preparation and Network Planning
Appendix C. "Technical Support"
CAUTION: Do not use a PC blade that shows any sign of damage. Using a
damaged blade can cause subsequent, extensive damage.
To protect ClearCube devices, keep them in their shipping containers until you install,
insert, or connect the devices.
A1410—Only insert in an A3100 chassis containing an expansion backplane.
A1010—Only insert in an A3000 chassis.
Save shipping containers and packing materials at least until your ClearCube
installation is complete and tested. Use shipping containers for RMAs (see
Merchandise Authorization
Chassis" on page 25 for instructions about unpacking and
"Installing a Blade in
on page 61.
(RMA)" on page 62for more information).
Chassis" on page 39 for instructions about
"Return