Safety Guidelines - ClearCube A1010 User Manual

Safety Guidelines

Before undertaking any troubleshooting or maintenance procedure, carefully read all
WARNING and CAUTION notices. Equipment displaying warning or caution notices
contains voltage hazardous to human life and is capable of inflicting personal injury.
• Installations—You must install ClearCube equipment in accordance with local electrical
codes. Equipment might be subject to inspection.
• Chassis grounding—ClearCube's chassis is designed with a three-conductor IEC 60320
appliance inlet that—with the proper power cord—connects the building's external
protective earthing conductor to all accessible metal parts of the enclosure. To minimize
shock hazard, make sure your electrical power outlet has an appropriate earth safety
ground that is connected each time you power on the equipment.
Swedish safety regulations require the following statement:
—Apparaten skall anslutas till jordat uttag när den anslutas till ett nätuerk.—
Finnish safety regulations require the following statement:
— Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan.—
• Power cord selection—ClearCube or ClearCube distributors provide power cords that are
specifically designed for use with particular pieces of equipment and are approved for use
by the local authority having jurisdiction in the country where the equipment is put into
service. Refer to the installation sections of this manual for specific power cord
requirements. For information about obtaining replacement power cords, see
"Technical Support"
• Power adapters—ClearCube or ClearCube distributors provide power adapters that are
specifically designed for use with particular pieces of equipment and are approved for use
by the local authority having jurisdiction in the country where the equipment is put into
service. Refer to the installation sections of this guide for specific power cord
requirements. For information about obtaining replacement power adapters, see
Appendix C. "Technical Support"
• IT power systems—ClearCube equipment has been evaluated and found to be compatible
with IT power distribution systems with a phase-to-phase voltage not to exceed 240 V.
• Live circuits—Operating personnel and service personnel must not remove protective
covers when operating the ClearCube chassis. Adjustments and service to internal
components must be undertaken by qualified service technicians. During any service of
this product, other than replacing a PC blade or externally accessible modules on the
x • Safety Guidelines
WARNING—A Warning notice in this manual indicates that
catastrophic equipment damage, or serious injury including death
may result if proper procedures are not followed.
on page 61.
on page 61.
Appendix C.