Inserting Paper Rolls Into The Integrated Printer - Thermo Scientific VARIOKLAV 25T Operating Manual

11.3 Inserting paper rolls into the integrated printer

INFORMATION
Do not pull the paper out of the printer. Use the Paper feed key
for this purpose.
Never pull the paper backward, because this may damage the
printer.
On commissioning the sterilizer, you need to insert a paper roll into the integrated
printer.
In addition, you must change the paper roll when there is almost no paper left. You
can tell that this is the case when a wide red line appears on the paper.
♦ Cut the end of the new paper roll as shown in Figure 18.
Figure 17: Cutting the end of the paper roll
♦ Press both the Printer ON/OFF key (26) and the Paper feed key (27)
♦ Remove the printer cover (25).
♦ Cut the paper strip off the old paper roll.
♦ Press the Paper feed key (27) until the remaining paper has been
♦ Remove the old paper roll from the paper roll compartment.
♦ Insert the new paper roll into the paper roll compartment so the end of
♦ Insert the end of the paper roll into the paper feeder.
♦ Press the Paper feed key (27).
The paper is now pulled into the printer head (Figure 19, right). It will curl slightly
upward.
♦ Replace the printer cover (25). Guide the paper through the slot of the
03/2007
11 Maintenance and cleaning
concurrently.
The printer cover (25) opens.
removed from the printer head.
the paper roll is below the roll.
printer cover (25).
53
DA0621_a/