Chapter 5: Basic Cli Operations; Prerequisites; Logging On; Configuring The Gateway From A Terminal - Avaya Advanced Gateway 2330 Manual

Using the command line interface

Hide thumbs Also See for Advanced Gateway 2330:

Table of Contents

Chapter 5: Basic CLI operations

Perform the basic CLI operations to log on to the switch, configure the switch from a terminal, or configure

the switch using saved configuration files from flash or the network.

• Valid CLI username and password. (Default username is admin and default password is

setup).

Log on to the CLI to access the switch configuration commands.

Procedure steps

1. After the AG2330 powers on and the following login prompt appears:

2. Enter your user password (default is setup)

For detailed information about configuring passwords and administering users, refer to Avaya

Advanced Gateway 2330 — Commissioning (NN47264-500).

Enter the configuration command mode from a console terminal or management workstation

to manually configure the gateway system parameters.

Using the Command Line Interface

enter the username (default is admin)

The CLI prompts for the password:

password:

August 2013

Table of Contents