Citizen SA-SD Operation Manual page 73

6-2-8-5 Number of Connected Units Check (Master Unit Only)
Parameter name
Number of connected units check
(PRS.CHK)
The number of connected controller units is checked and, if that number has changed, an error is output.
If the number is larger or smaller than that when this parameter was set to ON, an error is output.
When changing the number of connected controller units, set this parameter to OFF, change the number of
units, and then set the parameter to ON again.
Operation procedure
■
Long press
for 2 s
Note
■
The number of connected units check can only be set on master units.
Setting value
If controllers are connected, this performs a check when the
power is turned ON confirming that the number of connected units
has not changed.
ON / OFF
Select
Commit
6- 43
Remarks
[Default: OFF]
Cancel