Detailed Settings (Advanc); Hold Settings - Citizen SA-SD Operation Manual

6-2 Detailed Settings (ADVANC)

6-2-1 Hold Settings

Measurement mode
(MEAS)
Sample hold
(S-H)
Peak hold (P-H)
Bottom hold (B-H)
Peak-to-peak hold (P-P)
Peak-to-peak hold/2
(P-P/2)
NG hold (NG-H)
Self sample hold
(SLF.S-H)
Self peak hold (SLF.P-H)
Self bottom hold
(SLF.B-H)
Note
■
If the calculation app selection function is set to STAND (Difference from standard), the hold
setting of the master unit will be invalid.
Setting the calculation app selection function will invalidate the hold setting of the slave unit used
for the calculation.
Function
When (and only when) the external input is ON, the
controller holds and outputs the judgment value
(JUDGE.V).
When the external input is OFF, the judgment value
(JUDGE.V) is updated and output (real-time
output).
Holds and outputs the maximum value as the
judgment value (JUDGE.V).
Holds and outputs the minimum value as the
judgment value (JUDGE.V).
Holds and outputs the difference between the
maximum and minimum values as the judgment
value (JUDGE.V).
Holds and outputs half the difference between the
maximum and minimum values as the judgment
value (JUDGE.V).
Holds and outputs the LOW and HIGH judgments.
Static width After measurement
fluctuations have settled,
automatically self-triggers
holding and output of the
judgment value (JUDGE.V).
Delay timer After a delay, automatically
self-triggers holding and
output of the judgment value
(JUDGE.V).
Automatically self-triggers holding and output of the
maximum value as the judgment value (JUDGE.V).
Automatically self-triggers holding and output of the
minimum value as the judgment value (JUDGE.V).
6- 17
Refer to
6-2-1-1
Sample Hold Settings
6-2-1-2
Peak Hold Settings
6-2-1-3
NG Hold Settings
6-2-1-4
Self Sample Hold (Static
Width)
6-2-1-5
Self Sample Hold (Delay
Timer)
6-2-1-6
Self Peak Hold/
Self Bottom Hold