Changing The Length Of The Detector Cable - Citizen SA-SD Operation Manual

3-3 Changing the Length of the Detector Cable

Move the protecting cover in the direction of the arrow.
With a flat-blade screwdriver (tip width of 2 mm or less), push in the control lever (white) located at the
wire insertion port, and remove the wire.
Using the STRIP GAUGE shown on the side of the body, strip the cable sheath so as to expose 7 to
8 mm of core wire, and twist the core wires several times.
Using a flat-blade screwdriver of tip width of 2 mm or less, push in the control lever (white) of the control
section until it locks.
Tip width
2 mm or less
Protecting
cover
Flat-blade screwdriver
Control lever (white)
Wire
Length of core wires
Flat-blade screwdriver
3- 3
Control lever (white)