Tolerance <±> (Tol <±>) - Citizen SA-SD Operation Manual

6-1-5 Tolerance <±> (TOL <±>)
Parameter name
Tolerance <±> (TOL <±>)
Teaching method
This sets the HIGH and LOW
setting values automatically
using one reference work.
One-point teaching This is used to judge work with a
±tolerance.
Operation procedure
■
Long press
2秒長押し
for 2 s
HI.SET LO.SET
Related information
■
Setting Tolerance <±> only has an effect when the one-point teaching is selected.
For details of how to set the teaching method, refer to the preceding section.
When executing the one-point teaching, this parameter is set in
order to provide a tolerance from which the HIGH and LOW
setting values are derived, with the master work measurement
taken as the center value.
0.0000 to 199.9999 (mm)
Setting
ADVANC CALC COPY BANK
TEACH TEACH
Select
選択
Commit
確定
6- 9
Setting value
[Default: 0.1000]
+Tolerance = Tolerance
HIGH setting value
+Tolerance
Setting value
−Tolerance
LOW setting value
CALIB RESET MAINTE
/
PR.VAL PR.OBJ PR.SAVE DIRECT
Cancel
キャンセル
Shift between
Change numerical
digits
values
桁移動 数値変更
Remarks
LEVER SPEED OUTPUT