Citizen SA-SD Operation Manual page 33

Detailed settings (continued from the preceding page)
Alarm settings (ALARM)
Alarm delay time (DELAY)
Upthrust check
(PRS.CHK)
Upthrust check setting value
(PRS.SET)
Catching check
(CAT.CHK)
Number of connected units check
(PRS.CHK)
Calculation mode (CALC)
Calculation mode (MODE)
Select calculation app (APPLI)
Connected unit copy settings (COPY)
Select individual items to be
copied (CPY.SEL)
(Master unit only)
Select all items to be copied
(CHK.ALL)
(Master unit only)
Execute copy (CPY.EXE)
(Master unit only)
Copy lock (LOCK)
(Slave units only)
Bank settings (BANK)
Select bank storage (BNK.DAT)
Sets the delay time (changeable in 1 ms increments) from
the time the sensor head comes into upthrust position to the
time the alarm activates.
1 to 1,000
Sets the upthrust check ON/OFF.
ON / OFF
Sets the upthrust check setting value when the upthrust
check is set to ON.
−199.9999 to 199.9999 (mm)
Sets the catching check ON/OFF.
ON / OFF
If controllers are connected, this performs a check when the
power is turned ON confirming that the number of
connected units has not changed.
ON / OFF
This mode carries out calculations using measurements
from each connected controller, and outputs the judgment
results on the master unit display and from the master unit.
CALC (Calculates) / NOCALC (Does not calculate)
The Select calculation app can be set when calculation
mode is set to CALC.
This selects the application used for the calculation.
MAX (Maximum) / MIN (Minimum) / FLAT (Flatness) /
AVERAG (Average) / STAND (Difference from standard) /
TORSIN (Torsion) / CURVEA (Curvature) / THICK
(Thickness)
Items to be copied are selected individually.
Selects all items for copying.
YES / NO
The master unit copies the items selected for copying
(individually selected or all items) to the slave units.
YES / NO
Prevents copying from the master unit.
ON / OFF
Selects the settings to be read out from those stored in a
bank.
THRS (HIGH setting value, LOW setting value) / THRS.PR
(HIGH setting value, LOW setting value, Preset value) / ALL
(All)
6- 3
[Default: 1,000]
[Default: ON]
[Default: 10.0000]
[Default: OFF]
[Default: OFF]
[Default: NOCALC]
[Default: MAX]
[Default: YES]
[Default: YES]
[Default: OFF]
[Default: THRS]