Bringing Up The Management Interface - Cisco ASR-920-8S4Z-PD Hardware Installation Manual

Bringing Up the Management Interface

When you see this information, it means that you have successfully booted your router:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
.
.
.
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: yes
Press RETURN to get started!
Step 2
The first sections of the configuration script appear only at an initial system startup. On subsequent uses of
the setup facility, the script begins with a System Configuration Dialog as shown below: When you are
prompted about whether you want to enter the initial configuration dialog, enter yes.
Would you like to enter the initial configuration dialog? [yes/no] yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the system,
extended setup will ask you to configure each interface on the system.
Basic management setup configures enough connectivity for managing the system; extended setup will ask
you to configure each interface on the system.
Bringing Up the Management Interface
To bring up the management interface (required for configuring upload or download):
Procedure
Step 1
Router(conf)# boot ios
Step 2 Router(conf)# interface gig0
Step 3 Router(conf)# ip tftp source-interface gig0
Step 4
Router(config)# ip route vrf mgmt-intf 0.0.0.0 0.0.0.0 <gateway_ip >
Cisco ASR 920-10SZ-PD and Cisco ASR-920-8S4Z-PD Aggregation Services Router Hardware Installation Guide
64
Cisco ASR 920-10SZ-PD and Cisco ASR-920-8S4Z-PD Routers Initial Configuration