Table of Contents
Advertisement
Installation
2
Installation
Caution
A qualified service person should install the camera.
Except as described in this manual, do not open the camera for any reason. Damage to the camera
can occur as the result of careless handling or electrostatic discharge (ESD). Always handle the
camera with care to avoid damage to electrostatic-sensitive components.
Prior to making any connections, ensure the power supply or circuit breaker is switched off.
Be careful not to leave fingerprints on the camera's infrared optics.
Operating the camera outside of the specified input voltage range or the specified operating
temperature range can cause permanent damage.
This camera is designed to be installed indoors. The camera can be mounted directly on a wall or a
ceiling, or it can be mounted using the CB-WLBX-G4 Wall & Surface Mount Kit, which includes a junction
box. For the full list of accessories available for the camera, see the FLIR Security Cameras - Accessory
Guide.
2.1
Supplied Components
The Elara FR-345-EST camera kit includes these items:
2.2
Site Preparation
Select a suitable location to mount the camera.
The focus for both of the camera's sensors is fixed at one meter (39.4"). If it will be used in EST
screening mode, make sure to install the camera so that the faces of persons being screened for EST are
1m ± 0.2m (39.4" ± 7.9") away from the front of the camera.
Verify that the operating temperature range is between 15° ~ 45° C (60° ~ 110° F), 0-95% relative
humidity. The camera provides optimal performance in a stable environment near 22° (72°).
1.800.561.8187
427-0108-00-10 - Revision 100 - December 2020
This document does not contain any export-controlled information.
www.
.com
information@itm.com
5
Advertisement
Table of Contents
