Table of Contents
Advertisement
Installation
Interface
1 Micro SD card slot
2 USB
3 RESET (R)
4 DEFAULT (D)
5 STATUS
Anti-drop rubber
6
band
System cable
2.4
Supplying Power to the Camera
The camera can be powered by PoE or by an external DC or AC power supply (not included in the
camera kit).
1.800.561.8187
To be supported in a future release.
To be supported in a future release.
To reboot the camera, press the button for at least one second.
To reset the camera to its factory defaults, press the button for at least six
seconds.
LED (green / red / amber) that indicates camera is booting up or firmware
being upgraded.
Camera state
Booting up
Firmware
upgrade
Makes sure the access cover does not drop. To ensure that the camera
remains waterproof, store the anti-drop rubber band inside the camera
before locking the access cover.
1 Black
RJ-45
Red
ALARM IN signal
Black
ALARM IN GND
3
Brown
ALARM OUT signal
Blue
ALARM OUT COM
427-0108-00-10 - Revision 100 - December 2020
This document does not contain any export-controlled information.
www.
Description
LED state
Description
Normal
Solid red
After a successful boot,
Green
for 2-3
the LED turns off after
seconds,
three minutes.
then:
Red
An error has occurred.
Flashing amber
During upgrade
Connector
12-30 VDC (±10%) /
Black
24 VAC (21-28 VAC) -
2
12-30 VDC (±10%) /
Red
24 VAC (21-28 VAC) +
Yellow
NOT USED
Orange
NOT USED
Purple
NOT USED
Green
NOT USED
information@itm.com
.com
8
Advertisement
Table of Contents
