Additional Configuration - FLIR Elara FR-345-EST Installation And User Manual

Installation
Bracket for tilt adjustment (2): Adjust the
·
bracket. Do not exceed the 0°~ 90° tilt range
limit.
Retaining ring for 360° rotation (3): Rotate
·
the camera body. Do not exceed the ±360°
rotation range limit.
Important
While aiming the camera, make sure to
support the camera's weight with your hand.
Make sure that the toothed surfaces are properly aligned and meet
evenly.
Important
After aiming the camera, to prevent the camera from moving,
use the T10 torx wrench to securely tighten each locking screw.
To boresight the camera:
1. Use the default admin user or another user assigned either the
admin or expert role to
page.
2. On the View Settings Home
then click Boresight to open the
3. Use the controls and settings on the Boresight page to align the
visible video image with the thermal video image.
4. Click Save.
Important
After powering up the camera, wait 30 minutes before commencing screening. The camera's thermal
sensor needs to stabilize. In System Settings, click Boresight to open the
sure the Temperature is stable.
2.8

Additional Configuration

Depending on how you are using the Elara FR-345-EST camera, along with the network and VMS to
which it is connected, initial configuration using the camera's web page can also consist of:
Configuration task
Create users, assign roles, and change passwords
Adjust the camera's date and time settings
1.800.561.8187
access and log into the camera's web
Page, click System Settings, and
Boresight Page.
427-0108-00-10 - Revision 100 - December 2020
This document does not contain any export-controlled information.
www. .com
Aim the Camera
Align the Surfaces
Firmware & Info
Camera's default admin user
or any user assigned the
admin or expert role
User assigned the admin role
•
information@itm.com
Page. Make
Any user
13